If you are a motorcycle owner, you probably know the importance of having a motorcycle jack. It is a tool that allows you to lift your motorcycle off the ground for maintenance or repair. But what happens when your Craftsman motorcycle jack won't go down? This can be frustrating, especially when you have work to do on your bike. The good news is that there are several possible causes, and most of them can be fixed easily. In this article, we will discuss the causes and solutions of a Craftsman motorcycle jack that won't go down.
Causes of a Craftsman Motorcycle Jack That Won't Go Down
There are several reasons why your Craftsman motorcycle jack won't go down. Here are some of the most common:
1. Air in the Hydraulic System
One of the most common causes of a Craftsman motorcycle jack that won't go down is air in the hydraulic system. This can happen if the jack has been stored in a tilted position or if the hydraulic fluid has leaked out. When there is air in the system, the jack won't be able to generate enough pressure to lift the motorcycle off the ground.
2. Low Hydraulic Fluid
Another possible cause of a Craftsman motorcycle jack that won't go down is low hydraulic fluid. The hydraulic fluid is what powers the jack, and if the fluid level is low, the jack won't be able to work properly.
3. Damaged Release Valve
The release valve is what allows the jack to go down. If the release valve is damaged or worn out, it won't be able to release the pressure, which means the jack won't go down.
4. Blocked Hydraulic System
If there is a blockage in the hydraulic system, the jack won't be able to generate enough pressure to lift the motorcycle off the ground. This can happen if the hydraulic lines are blocked by dirt, debris, or rust.
Solutions to a Craftsman Motorcycle Jack That Won't Go Down
Now that we have discussed the possible causes of a Craftsman motorcycle jack that won't go down, let's talk about the solutions:
1. Bleed the Hydraulic System
If there is air in the hydraulic system, you will need to bleed it. To do this, you will need to locate the bleeder valve on the jack and open it. Pump the jack handle a few times and then close the valve. Repeat this process until all the air is out of the system.
2. Check and Refill the Hydraulic Fluid
If the hydraulic fluid level is low, you will need to check and refill it. Make sure to use the recommended type of hydraulic fluid for your jack.
3. Replace the Release Valve
If the release valve is damaged or worn out, you will need to replace it. You can purchase a replacement valve from the manufacturer or a local hardware store.
4. Clean the Hydraulic System
If there is a blockage in the hydraulic system, you will need to clean it. Start by disconnecting the hydraulic lines and flushing them out with a cleaning solution. Reconnect the lines and refill the hydraulic fluid.
Conclusion
A Craftsman motorcycle jack that won't go down can be frustrating, but it is usually easy to fix. By following the solutions discussed in this article, you should be able to get your jack working properly again. Remember to always check your jack before using it, and follow the manufacturer's instructions for maintenance and repair.
Related video of Craftsman Motorcycle Jack Won't Go Down: Causes and Solutions