My Motorcycle Has Been Sitting For 2 Years
Have you left your motorcycle sitting for 2 years without use? If so, you may be wondering what to do next. Don’t worry, you are not alone. Many motorcycle owners have faced this situation and with the right steps, you can get your motorcycle back up and running in no time.
Inspect Your Motorcycle Thoroughly
Before you start your motorcycle, it is important to perform a thorough inspection. Check for any leaks, cracks, or damages to the body or engine. Look for signs of rust or corrosion as well. Check the tires for any punctures or cracks. Ensure that the brakes and suspension are functioning properly. Also, check the battery, oil level, and fuel tank for any issues.
Replace The Battery
If the battery has been sitting for 2 years, it is likely that it will need to be replaced. Over time, batteries lose their charge and can even become damaged if left unused for too long. Replace the battery with a new one to ensure that your motorcycle starts up smoothly.
Flush And Refill The Fuel Tank
After 2 years, the fuel in your tank may have gone bad. Old fuel can cause clogs and other issues in the engine. Drain the old fuel and replace it with fresh fuel. This will ensure that your motorcycle runs smoothly and efficiently.
Change The Oil And Filter
Oil breaks down over time, even when the motorcycle is not being used. It is important to change the oil and filter to ensure that your motorcycle is properly lubricated. This will help to prevent engine damage and ensure that your motorcycle runs smoothly.
Check The Tires
After sitting for 2 years, the tires may have lost pressure or even become damaged. Check the tire pressure and fill them up if necessary. If the tires are cracked or damaged, replace them with new ones. This will ensure that your motorcycle is safe to ride and will provide proper traction on the road.
Clean The Motorcycle
After sitting for 2 years, your motorcycle may be covered in dust, dirt, and debris. Clean the motorcycle thoroughly using soap and water. This will help to prevent any damage caused by buildup on the body or engine. Additionally, it will make your motorcycle look shiny and new.
Conclusion
Getting your motorcycle back on the road after sitting for 2 years can seem like a daunting task. However, by following these steps, you can ensure that your motorcycle is running smoothly and safely. Remember to perform a thorough inspection, replace the battery, flush and refill the fuel tank, change the oil and filter, check the tires, and clean the motorcycle. With a little bit of effort, you can enjoy riding your motorcycle once again.