Led Turn Signals Not Working On Motorcycle
Motorcycles are a popular mode of transportation in the United States, and as with any vehicle, they require maintenance and repairs to keep them running smoothly. One of the most common issues that motorcycle riders face is turn signals not working properly. This can be a frustrating problem, as it not only puts the rider at risk but also other drivers on the road. In this article, we will discuss the reasons why led turn signals might not be working on a motorcycle and how to fix them.
Reasons for Led Turn Signals Not Working On Motorcycle
There are several reasons why turn signals might not be working on a motorcycle, including:
- Blown Fuse
- Burnt Out Bulb
- Bad Relay
- Wiring Issues
- Loose Connections
- Corrosion
If the turn signals are not working, the first thing you should check is the fuse. The fuse is usually located in the fuse box, which is generally located under the seat or in the side panel of the motorcycle. If the fuse is blown, replace it with a new one of the same amperage. If the fuse blows again, there may be a short circuit in the wiring, and it is best to take the motorcycle to a mechanic.
If the fuse is not the problem, the next thing to check is the bulbs. Turn signals use a small bulb that can burn out over time. To check the bulbs, remove the lens cover and inspect the bulb for any damage or discoloration. If the bulb is burnt out, replace it with a new one of the same size and wattage.
If the bulbs are not the issue, the problem may be with the relay. The relay is the component that controls the turn signal circuit. If the relay is not working properly, the turn signals will not function. To check the relay, locate it in the fuse box and replace it with a new one.
Wiring issues and loose connections can also cause turn signals to stop working. Check the wiring for any damage or wear and make sure all connections are tight. If any wires or connections are damaged, they should be repaired or replaced.
Finally, corrosion can cause turn signals to stop working. Corrosion can occur in the wiring or in the socket where the bulb is inserted. To fix this problem, clean the affected area with a wire brush or sandpaper and apply a small amount of dielectric grease to prevent further corrosion.
How to Fix Led Turn Signals Not Working On Motorcycle
The following steps can be taken to fix led turn signals that are not working on a motorcycle:
- Check the fuse
- Check the bulbs
- Check the relay
- Check the wiring and connections
- Clean any corrosion
If none of these steps work, it is best to take the motorcycle to a mechanic for further diagnosis and repair.
Conclusion
Motorcycle turn signals are an important safety feature that should not be ignored. If the turn signals are not working, it is important to diagnose and fix the problem as soon as possible. By following the steps outlined in this article, you can fix led turn signals that are not working on your motorcycle and ensure your safety on the road.
