Motorcycle Goes In Gear But Wont Move
As a motorcycle rider, there are few things more frustrating than putting your motorcycle into gear and then realizing that it won't move. There are several reasons why this could be happening, and in this article, we will discuss some common causes and solutions for this issue.
1. Clutch Problems
One of the most common causes of a motorcycle going into gear but not moving is clutch problems. The clutch is responsible for disengaging and engaging the engine from the transmission. If the clutch is not working correctly, it can cause the motorcycle to stall when you try to move it.
Solution: Check the clutch cable for any damage or stretching. If the cable is damaged, replace it. If the cable is fine, then the clutch plates may be worn and need to be replaced. You can also try adjusting the clutch cable to see if that helps.
2. Low Gear Oil
If the gear oil level is low, it can cause the motorcycle to go into gear but not move. The gear oil lubricates the transmission and allows the gears to move smoothly. If the oil level is low, there may not be enough lubrication for the gears to move properly.
Solution: Check the gear oil level and add more if necessary. Be sure to use the correct type of gear oil for your motorcycle, as using the wrong type can cause damage to the transmission.
3. Clutch Plates Sticking
If the clutch plates are sticking together, it can cause the motorcycle to stall when you try to move it. This can happen if the motorcycle has been sitting for a long time or if the clutch plates are dirty.
Solution: Try to free up the clutch plates by rocking the motorcycle back and forth while in gear. If this doesn't work, you may need to remove the clutch plates and clean them. Be sure to use a clutch cleaner that is safe for your motorcycle.
4. Transmission Problems
If the transmission is damaged, it can cause the motorcycle to go into gear but not move. This can happen if the motorcycle has been in an accident or if the gears are worn or damaged.
Solution: Take your motorcycle to a mechanic to have the transmission inspected. Depending on the extent of the damage, you may need to have the transmission repaired or replaced.
5. Chain or Belt Issues
If the chain or belt is loose or damaged, it can cause the motorcycle to go into gear but not move. The chain or belt is responsible for transferring power from the engine to the rear wheel.
Solution: Check the chain or belt for any damage or stretching. If it is damaged, replace it. If it is fine, then adjust the tension to see if that helps. Be sure to use the correct tension settings for your motorcycle.
Conclusion
There are several reasons why a motorcycle could go into gear but not move. Some of the common causes include clutch problems, low gear oil, clutch plates sticking, transmission problems, and chain or belt issues. It's important to address these issues as soon as possible to prevent further damage to your motorcycle.